1Set Upgrade 3D Printer Z-probe BLTouch Auto Leveling Sensor Auto Bed Leveling Sensor Touch For Anet A8 Mk8 I3 Improve Precision

  • US $10.69
  • US $13.20
  • 19% off

Store Name XJW TECH DEMO BOARD Store
SKU 32962926616
Shipping Free Shipping
Availability In stock
Last Update Sat, 22 Feb 2020 01:19:31 +0000
  • Product Details

    1Set Upgrade 3D Printer Z-probe BLTouch Auto Leveling Sensor Auto Bed Leveling Sensor Touch For Anet A8 Mk8 I3 Improve Precision Product Details:


    Brand Name FYSETC
    Item Type Leveling Modules
    Model Number 3d printer z-probe touch
  • Product Description

    1Set Upgrade 3D Printer Z-probe BLTouch Auto Leveling Sensor Auto Bed Leveling Sensor Touch For Anet A8 Mk8 I3 Improve Precision Product Description:


    1Set Upgrade 3D Printer z-probe Touch Auto Leveling Sensor Auto Bed Leveling Sensor Touch for Anet A8 mk8 I3 Improve Precision

    Voltage5V
    Current15mA
    Maximum(Peak)Current300mA
    ColorSemitransparent Black
    Cable Length150mm
    Weight0.35 oz(10g)
    Wiring3Pin:Black(-,GND)
    Red(+5V)
    Blue(control Signal)
    2Pin:Black(-,GND)
    Yellow(Zmin)

    3D printer z-probe Touch uses the same servo signal which used in previous servo line.


    ■ Solenoid Push-pin Up ➡ servo signal 90Degree(ex : M280 P0 S90 )
    ■ Solenoid Push-pin Down ➡ servo signal 10Degree(ex : M280 P0 S10 )
    ■ Manual Self-test ➡ servo signal 120Degree(ex : M280 P0 S120)
    ■ Alarm Release ➡ servo signal 160Degree(ex : M280 P0 S160)
    ※ 3D pirnter z-probe Touch can be operated in the following condition.
    - One I/O (PWM or Software PWM) for control
    - One I/O for Zmin
    - GND and +5V power
    However, Firmware updating might be needed on a case.
    If you use this on an Anet A8 then you need to cross over the YELLOW & BLUE wires. Couldn't figure out why it wouldn't work until I read the head unit. The Yellow is the endstop and the Blue is the pwm input, I just cut them and reversed them.

  • Related Searches

Related Products